12mm Diameter Flat End Engraving Bits
12mm Diameter Flat End Engraving Bits
$16.99  $12.99
PCD Bits
PCD Bits
$32.99  $29.99
12mm Diameter Flat End Engraving Bits
12mm Diameter Flat End Engraving Bits
$16.99  $12.99
PCD Bits
PCD Bits
$32.99  $29.99
Sunday 24 July, 2011 | RSS Feed

How to Install CNC Router Collet

by ASTECH-CNCTools

How to Install CNC Router Collet

 

CNC router collet is widely used in engraving, boring, milling, etc.

So how to install router collets?

 

1.    Put cnc collet into clamping nut.

(1)  Spin snap spring gently.

(2)  After eccentric part of nut sunk into circlip slot, push the clamp spring hard in the direction of the arrow.

Warm notice: the strength should be equal, especially to cnc router collet.

 

2.    Install snap spring and pressing cap into collet chuck or CNC router spindle together.

(1)  Clean cnc tools shank, then reload into the clamping hole.

(2)  Fasten cap by wrench, until cnc router tools are held tightly.

 

3.    When remove router bit, loosen pressure cap by spanner to take out cnc router collet and cnc machine cutting tools. Then, force spring to make it exist in the direction of arrow. At last, replace a new one as needed.

  

4.    Useful tips:

(1)  Don’t fix nut before tool installation, avoiding damaging circlip.

(2)  Put some grease on cutter shank, spring head and cnc router collet, which is easy to install or remove.

 






News for Friday 22 July, 2011


View all news for Friday 22 July, 2011 on one page




Recent News




News archive